anaerobic adhesives and sealants are advanced technology products with single component and solvent-free structure. These products are specially formulated for sealing and fixing metal and metal coated parts.

Bottle: 15mL, 50mL and 250mL
Large volume: 1kg and 10kg

Can be used on all bolt and nut sizes. It has a special formulation that does not drip and flow after gluing. It is used in machine adjustment bolts, screws of bearing protective containers, conveyor belt bolts. Resistant against leaks, corrosion, many chemicals, fuel oil, oils and gases.

• Resilience: Centre
• Viscosity Medium-ixotropic
• Colour: Blue
• Appearance (uncured): Liquid
• Basic component: Methacrylate ester

• Specific gravity Conditions: 22°C: 1.030
• Flash point Method: ASTM D56-05: >93°C
• Temperature range: -50°C to +150°C
• Corrosion properties: Not corrosive
• Gap filling: up to 0.25mm
• Viscosity 4000- 5000 cPs (@20

Coefficient of thermal expansion (α) Method: ISO 11359-2 6x10-7 K-1
Coefficient of thermal conductivity (k) Method: ISO 8302 0.21 W/(m.K)
Specific Heat Method: ISO 11357-4 0.22 kJ/(kg.K)

The environmental resistance of the cured adhesive was measured by applying ISO 10964 preloaded assembly test at different temperatures after curing.

• Test method ISO 10964
• Bolt and nut samples: Zinc plated, M10x25
• Curing conditions and time: 22°C, 1 week
• Torque test conditions (except high temperature withstand test): 22°C
• Type of torque Breakaway torque (TBL)

1. Before joining the male and female parts, clean them with an absorbent cloth or wipe to thoroughly remove the cutting oil.
2. Apply the adhesive 360 degrees to the first threads of the male and female pipe fittings.
3. Wipe off excess product in the direction of the teeth with an absorbent cloth or tissue.
4. Assemble the parts and leave at 22-24°C for 24 hours to ensure complete curing.
5. To disassemble, use hand tools when separating joined parts. If disassembly at room temperature is not possible, apply localised heating to 250°C and disassemble while hot. Then mechanically remove any remaining cured adhesive and clean the parts with a suitable solvent, e.g. acetone.

Store the product in its original container at 22°C and do not expose to direct sunlight. Storage at temperatures less than 5°C and more than 30°C may adversely affect product properties. Product removed from the original container may become contaminated during use and this may affect the adhesion performance and shelf life of the product. Therefore, do not return the contaminated product to its original container. Akfa Industry does not accept responsibility for products that are contaminated or stored in a manner other than the specified storage conditions.

Shelf life 24 months at 22°C

The product contains methacrylate ester. For more detailed information, please consult the Safety Data Sheet (SDS) before use